It is relatively common for these errors to appear after updating the operating system and to generate conflicts with the drivers. We may run into the situation that there is some corrupt file and that after updating it causes the Ethernet network card to malfunction. This always helps to make everything work correctly, improve performance and also avoid security problems that could compromise us.īut sometimes those updates have been able to give errors. Updating our equipment and systems is very important. It’s going to stop working permanently until we fix it.
That is to say, it does not usually appear in small cuts, but we will directly go offline and have to resolve the possible conflict with the device’s drivers and thus be able to navigate normally. However, this type of error is usually blocking. This could lead to conflicts with the operating system or not to recognize the USB port to which it is connected. Of course another very common problem is that we have some kind of problem with the adapter’s firmware. We must also think that the problem may be due to the USB port itself that does not make the internal connection well. For example if the adapter is loose and with some movement it moves and disconnects. Keep in mind that it will not always be caused by the fact that the card is badly connected. This will logically happen if we are using a card that connects to the USB port, something that is increasingly common in smaller laptops. With total security it is one of the most common causes that the network adapter does not work well, the signal is disconnected and we cannot navigate.
A bad placement of the card in the USB port, for example, could lead to us going offline. It can be due to a configuration failure, but also at the hardware level. We are going to show what are the main reasons for the Ethernet network adapter to disconnect and stop working properly.